Ihr Warenkorb ist leer
 

USB-Lademodul für Lithium Akkus mit Schutzschaltung MicroUSB

0.30EUR
inkl. 19% MwSt.
zzgl. Versandkosten

 

 

 

 

USB-Lademodul für Lithium Akkus mit Schutzschaltung Tiefentladung und Überladung. Auf dem Modul kommt ein TP4056 als Laderegler zum Einsatz, das IC DW01B überwacht zusätzlich die Ausgangsspannung und trennt den Akku vom Ausgang bei unterschreiten der Akkuspanng von 2.4V vom Ausgang, ebenso bei überschreiten von 4,25V. Der Ladestrom ist mit einem Widerstand auf 1000mA eingestellt.  Zwei LED zeigen den Ladezustand an.

Anschlüsse am Lademodul:

  • Eingang MicroUSB oder IN-,IN+
  • Akku an B+,B-
  • Ausgang OUT+,OUT-

Datenblatt TP4056

Datenblatt DW01B

 

TP4056 - Micro USB 5V 1A Lithium Battery Charger with Protection

Description

This tiny module is perfect for charging single cell 3.7V 1 Ah or higher LiPo cells such as 16550s that don't have their own protection circuit.

Based around the TP4056 charger IC and DW01 battery protection IC this module will offer 1A charge current then cut off when finished.

Futhermore when the battery voltage drops below 2.4V the protection IC will switch the load off to protect the cell from running at too low of a voltage - and also protects against over-voltage and reverse polarity connection (it will usually destroy itself instead of the battery) however please check you have it connected correctly the first time.

Using the module

  • Connect micro USB cable for power, or 5V DC to pads marked IN+ and IN- on left-hand side of the module
  • Connect cell to charge to B+/B- pads on right-hand side of module
  • A load (something for the battery to power) can be connected to the OUT+/OUT- pads on the right-hand side
  • Important! Disconnect load when charging
  • The red LED indicates chaging in progress, green LED indicates charging has finished.
  • Never charge your battery at a rate greater than 1C.

Specifications

  • Input voltage - 5V via microUSB or solder pads on left-hand side of module
  • Full charge voltage - 4.2V
  • Charging current - 1A by default. However you can change this by changing the 1k2 resistor next to the "IN-" pad the bottom-left of the board. See the Rprog table on page three of the TP4056 data sheet for different values and matching charging currents

 

 

 

 

 


Anzahl:

  • Artikelnummer: KP02013
  • 13 Stück auf Lager
  • Hergestellt von: Diverse


Dieser Artikel wurde am Montag, 29. August 2016 im Shop aufgenommen.

 
     
Find us on Facebook PayPal Accepted

Copyright © 2024 komputer.de. Powered by Zen Cart